This code is set when the engine is running too rich or too lean. There could be several issues, I would start with monitoring the oxygen sensor voltage and see if it is staying above .5 volts (rich)...
Posts by Admin
This the event code 304 for a crown on the SP InfoPoint. This is the error code 304 for the walkie pallet. The 304 code is for low battery voltage. Check the emergency disconnect switch for...
Unicarriers Caterpillar Mitsubishi Error Code E35 and Inspection Procedures for LPG Injector
There are a few issues with the LPG injector that can be easily diagnosed. First check the 5A fuse next to the injector, this will determine if the injector may be shorted internally. Next, unplug...
These error codes set when the diesel exhaust filter needs to be cleared by performing a regenerative procedure. CODES DTC 3701-15 - Excessive Particulate Matter 3DTC 3701-16 - Excessive...
DTC 523592-2 - Regeneration Switch Message Error POSSIBLE CAUSEA. CANBUS COMMUNICATION FAULTB. ACU FAULT COMPONENT OPERATIONAL CHECKPROCEDURE OR ACTION: Turn power to OFF for no less than 30...
Brake Switch (BRS1) depressed for more than 5 seconds while requesting traction. –04 This code indicates voltage at CA401-13 on master controller (MRC1) and CA403-13 on slave controller (MRC2)...