Category: Error Codes

This code is set when the fingertip hydraulic levers are out of range when the key is turned on. Moving each lever back and forth will usually clear the code until the key is cycled again. To reset...

TOSS/TISS Sensor Signal Intermittent/No Output TISS - Transmission Input Speed SensorTOSS - Transmission Output Speed Sensor Transmission Output Speed Not Proportional to Transmission Input...

Identifiers to determine which device generated the code: Node X = XXXX (12544 Node 3)Node 2 = TractionNode 5 = PumpNode 6 = Steer MasterNode 7 = CAN I/O MasterNode 8 = CAN I/O SlaveNode 11 =...

This is the Caterpillar & Mitsubishi three wheel sit down DC trucks with Micro Command. E0Right Motor, OverheatingE1Left Motor, OverheatingE2Pump Motor, OverheatingE3Controller,...

I found these error codes and procedures to work on the Clark forklift with the Hyundai engine. Displaying Fault Codes from ECM Memory To enter code display mode, you must turn OFF the ignition...

These status codes are found on the older style Hyster/Yale three and four-wheel sit-down forklifts. Keep in mind, these are status codes and not necessarily error codes. Some of them are operator...